Tel
13924628001
Tel：
86-13924628001
Product Description:
1. The antenna is a part of the digital beamforming self-tracking system. The unit adopts orthogonal symmetrical oscillator structure and hexagonal structure arrangement, and receives left-right circular double-circular polarization signals through circular polarization network;
2. The antenna is a calibration network, and the input reference signal is distributed to seven dual-channel low noise amplifiers according to the principle of constant amplitude in phase; According to the control signal, the low noise amplifier chooses the access antenna to receive the signal or the calibration reference signal;
3, amplifier circuit gain is high, low noise factor, with high dynamic reception function;
4, the antenna structure head tilt, consistent with the top of the cabin, part of the structure using stainless steel material, with enough strength to meet the vibration requirements of the aircraft.
Electrical Specifications
Passive antenna:
Frequency Range(MHz)：2200～2300
Gain(dBi)：≥6（Zenith gain）
Polarization：Double circular polarization
Dual low noise amplifier:
Frequency Range(MHz)：2200～2300
LNA Gain(dB)：35±2
Mode control signal:
Through-core capacitance, TTL level, inverter isolation
The high level corresponds to the antenna signal, and the low level corresponds to the reference signal
Status control signal:
Through-core capacitance, TTL level, inverter isolation
High level corresponds to high gain, low level corresponds to low gain
Burn-out resistance (dBm) : 20dBm continuous wave
Calibration mode isolation: the antenna signal is cut off, and the insertion loss is not less than 40dB
Calibration port consistency: The amplitude difference between the calibration port and the two inputs does not exceed ±0.2dB. The phase difference between the calibration port and the two inputs does not exceed ±1°
Mechanical Specifications
Connector：Power port:J30J-9ZK
Rf port :TNC-K
Serial port :J30J-15ZKP
Network port :J30J-15ZKP
Dimensions(mm)： Ф182.1×559.72
Weight(kg)：＜15
